KWS 1091..

Door holder with hook, holding mode can be deactivated (with key)

Back to overview

Picture shows KWS 1092.31

Drawing shows KWS 1091..

Do you have questions regarding the product?
We are happy to advise you!

Configure product

Variant

Please make a new selection.

Finish

Please make a new selection.

Article number

KWS 1091.021091.02125

Please correct all errors and fill in all fields.

Please enter a quantity.

Quantitypiece(s)

Downloads

Product information
KWS 1091..
Door holder with hook, holding mode can be deactivated (with key)
deactivation of the holding mode is possible
with locking device (with two keys)
holder with anchor bolt for casting in (KWS 1009..) or without anchor bolt to be screwed (KWS 1010..), roller block to be screwed
door closer can be used

Material
aluminium
anchor bolt (for KWS 1091..):
steel, hot-galvanized
roller block:
steel or stainless steel
buffer:
rubber, spring-loaded, black

Mode of operation
foot actuation

Door weight
max. 100 kg

Unit weight
0,870 kg (KWS 1091..)
0,580 kg (KWS 1092..)
Function
To hold the door in place, push it against the holder until the hook is engaged on the roller block. Actuating the hook while simultaneously pressing the door against the holder disengages the holding mode.
The lever, switched from position A to B (see product drawing), deactivates the holding mode: In this case, the door holder only has the function of a spring-loaded door buffer.
The locking device stops the hook on the door holder from being actuated: Consequently, the open door cannot be closed.
Installation
With anchor bolt (KWS 1091..)
Grout the anchor bolt at the desired arresting point into the floor, which should be the furthest possible distance from the door hinge. After the grouting material has hardened, mount the door holder on with four screws. Fix the roller block to the door at the corresponding position.
Without anchor bolt (KWS 1092..)
Mount the door holder on the floor with four screws and inserted plugs at the desired arresting point, which should be the furthest possible distance from the door hinge. Fix the roller block to the door at the corresponding position.
For height compensation, the additional use of the shim KWS 1610.. (20 mm high) is recommended.
Downloads
Product drawing KWS 1091.. (DWG)
Product drawing KWS 1092.. (DWG)